 |
| English |
| Français |
| Deutsch |
| Italian |
| Spanish |
 |
| About Us |
| Our Products |
| Marking |
| Enquiries |
| Re-order |
| Safe Mounting |
| Grits and Grains |
 |
| General Brochure |
| Bearing Grinding |
| Machine Knives |
| Spring Grinding |
| Engine Reconditioning |
| Amada Togu |
 |
| Terms & Conditions of Sale |
 |
| Worldwide Jowitt Bridge Way Broombank Road Chesterfield Trading Estate Chesterfield S41 9QJ United Kingdom Tel: +44 (0)1246 572230 Fax: +44 (0)1246 572249 web: www.jowitt.com e-mail: sales@jowitt.com |
Search
|
Mounting
Inserted Nut Discs and Inserted Nut Cylinders |
||
 Page 5 |
||
Mounting the Wheel on the Backplate.
|
| 1. When mounting a
wheel on to a horizontal spindle machine where the backplate
is not removed, take care to centre correctly before tightening
any screws. 2. When mounting an inserted nut disc on the top of a double head vertical spindle machine, it is important that the wheel is in full contact with the backplate before tightening any fixing screws. All screws should be fully tightened prior to removal of the wheel supports in order that no sudden loads are placed on the nut inserts. |
3. Never suspend the wheel on
loose fixing screws as this could cause nut failure allowing
the wheel to fail. 4. The wheel should be finally visually inspected and then run to the operating speed before any grinding operation. |
EO&E and Copyright © Jowitt 1995 - 2018